PPP Support (PPTP)

How to enable PPP support on your VPS:

1. Go into the Server Management Control Panel.

2. Go to your VPS > Manage > Controls > Settings.

3. Click the button that says "Enable PPP".

The system will now automatically enable PPP and restart your VPS. Give it a few minutes to complete this task before you touch or do anything else.

Once your VPS is fully booted back up you should now have PPP support.

 

How to check that TUN is actually enabled on your VPS:

1. Go into your servers terminal.

2. Run this code:

cat dev/ppp

3. If the system responds "No such device or address" then PPP is enabled.

If you get something else then PPP is not enabled. Repeat the process described at the top of this article. Turn off PPP, wait and let the VPS fully reboot, Enable PPP, and let the VPS fully reboot.

Was this answer helpful?

 Print this Article

Also Read

TUN Support (TUN/TAP)

How to enable TUN support on your VPS:1. Go into the Server Management Control Panel.2. Go to...

How to Install VNC

This guide will walk you thru the steps to install VNC on Ubuntu. Note: VNC can use a lot of...

Can I purchase additional IP's?

Yes.If you would like to purchase additional IP's just open up a ticket with Billing and...

Do you have rDNS support?

Yes. We fully support rDNS entries on both our IPv4 and IPv6 IP's.If you require an rDNS entry on...

How to block port 25

If you are not sending email from your VPS, you may want to block access to port 25. This can...